奥斯达蓄电池6FM40 直流110V40AH系统性能及使用寿命：
1）奥斯达蓄电池外观：无变形、裂纹、裂痕；
2）气密性：内外压差50Kpa时不漏气，外壳不变形；
3）奥斯达蓄电池应采用高灵敏度低压气阀，既保证排出过压气体，又不致渗液，电池无鼓胀现象；
4）AUSSDA蓄电池内部应为凝胶电解质，无游离液体存在，在任何方位放置及在强充情况下，均应没有液体渗出；
5）电解质应均匀，上下一致，在大电流放电的情况下，无极板变形；
6）过充电性能：无变形、无漏液；
7）安全阀动作：开阀压40Kpa以下，闭阀压1.0Kpa以上；
8）自放电率：每天的自放电率应小于其额定容量的0.1%；
9）奥斯达电池应具有良好的均匀性；
10）奥斯达电池内部应有过放保护装置，深放电后的电池仍可接在负载上，在四周内恢复供电仍可恢复至原容量；
11）奥斯达蓄电池设计寿命应不低于6年。
1) AUSDA battery appearance: no deformation, crack, crack;
2) Air tightness: no air leakage when the pressure difference between inside and outside is 50kPa, and the shell is not deformed;
3) Aosda battery should use a high sensitivity low pressure valve, not only to ensure the discharge of overpressure gas, but also not seepage, the battery without bulging phenomenon;
4) The inside of AUSSDA battery should be gel electrolyte, and there should be no free liquid. There should be no liquid leakage when placed in any direction and under the condition of strong charging;
5) the electrolyte should be uniform, consistent up and down, in the case of large current discharge, no plate deformation;
6) Overcharging performance: no deformation, no leakage;
7) Safety valve action: open valve pressure below 40KPa, closed valve pressure above 1.0KPa;
8) Self-discharge rate: daily self-discharge rate should be less than 0.1% of its rated capacity;
9) Ausstar batteries should have good uniformity;
10) Ausstar battery internal should be over-discharge protection device, after deep discharge of the battery can still be connected to the load, within four weeks to restore power supply can still restore to the original capacity;
11) The design life of AOSTAR battery should not be less than 6 years.
